The Reason Why The Centrifugal Pump Does Not Fill Water

Centrifugal pumps are simple in structure, easy to use and maintain, and have high efficiency. They are widely used in agriculture and other fields. However, sometimes there will be a failure of no water supply. The technicians of Shenlong Pump Industry analyzed and learned that the main reasons are:

1. The speed of the centrifugal water pump is too low

(1) Mechanical failure of the pump itself. The impeller and the pump shaft fastening nut loose or the pump shaft is deformed and bent, causing the impeller to move too much, directly rubbing against the pump body, or bearing damage, which may reduce the speed of the pump.
(2) The transmission belt is worn. Many large-scale centrifugal pumps use belt transmission. Due to long-term use, the transmission belt is worn and loosened and slipped, thereby reducing the speed of the pump.
(3) Human factors. A considerable part of the users arbitrarily equipped with another motor to drive because the original motor was damaged, resulting in the consequence of small flow, low lift or even no water supply.

2. There is air in the pump body of the centrifugal water pump

The packing of the water pump has been worn out due to long-term use or the packing is too loose, causing a large amount of water to be ejected from the gap between the packing and the shaft sleeve of the pump. As a result, the external air enters the inside of the pump from these gaps, which affects the lift. water.

3. There is air in the inlet pipe of the centrifugal water pump

(1) There are cracks in the elbow of the inlet pipe, and there is a tiny gap between the inlet pipe and the water pump, which may cause air to enter the inlet pipe.
(2) Some users have not filled enough water before the pump is started. Sometimes it seems that the filled water has overflowed from the vent hole, but the pump shaft is not turned and the air is completely discharged, resulting in a little air remaining in the water inlet pipe.
(3). Due to long-term potential underwater, the pipe wall has corroded holes, and the water surface drops continuously after the pump is working. When these holes are exposed to the water surface, air enters the civil water inlet pipe from the holes.


Post time: 2021-11-30
  • Previous:
  • Next:
  • Tags:

  • Write your message here and send it to us
    Related Posts
    • 180KW 4500 M3/Hr 26 Inch 650HW-10 Mixed Flow Pump
      180KW 4500 M3/Hr 26 Inch 650HW-10 Mixed Flow Pump

      650HW-10 Mixed Flow Pump Flow 4500 M3/Hr At 14 M Suction/Discharge 26 Inch Data: Type: 650HW-10 Power(KW): 180KW Speed(rpm): 590 Flow(m3/h): 4500m3/h Head(m): 14 Outlet size: 26inch Inlet size: 26inch Shaft power: 177.3 kw Efficiency: 88% Voltage: 3 phase 380V Frenquency: 50HZ Pump case: Cast iron Shaft: 3Cr13 Impeller: Cast iron Seal type: Gland packing …

    • 75KW 1500 M3/Hr 16 Inch 400HW-7 Mixed Flow Pump
      75KW 1500 M3/Hr 16 Inch 400HW-7 Mixed Flow Pump

      400HW-7 Mixed Flow Pump Flow 1500 M3/Hr At 14 M Suction/Discharge 16 Inch Data: Type: 400HW-7 Power(KW): 75KW Speed(rpm): 980 Flow(m3/h): 1500m3/h Head(m): 14 Outlet size: 16inch Inlet size: 16inch Shaft power: 66.3 kw Efficiency: 84% Voltage: 3 phase 380V Frenquency: 50HZ Pump case: Cast iron Shaft: 3Cr13 Impeller: Cast iron Seal type: Gland packing …

    • 37KW 1000 M3/Hr 12 Inch 300HW-8 Mixed Flow Pump
      37KW 1000 M3/Hr 12 Inch 300HW-8 Mixed Flow Pump

      300HW-12 Mixed Flow Pump Flow 1000 M3/Hr At 12 M Suction/Discharge 12 Inch Data: Type: 300HW-8 Power(KW): 37KW Speed(rpm): 970 Flow(m3/h): 1000m3/h Head(m): 12 Outlet size: 12inch Inlet size: 12inch Shaft power: 31.72 kw Efficiency: 85% Voltage: 3 phase 380V Frenquency: 50HZ Pump case: Cast iron Shaft: 3Cr13 Impeller: Cast iron Seal type: Gland packing …

    • 355KW Horizontal Centrifugal Pump Used In Sewage Of Dry-dock
      355KW Horizontal Centrifugal Pump Used In Sewage Of Dry-dock

      355kw horizontal centrifugal pump used in sewage of dry-dock data fluid: salt water motor: 380 v – 50 hz flow: 4379 m3/h, max. manometric height: 25 m suction height: 5/7 m body material: cast iron impeller material: stainless steel 316 place of work: sewage of dry-dock We offer for centrifugal pumps and submersible pump for …

    • 30KW 40HP 160M3/H Pump For Construction Of Sewage Station
      30KW 40HP 160M3/H Pump For Construction Of Sewage Station

      Construction Of Sewage Station A sewage system is made up of a network of pipes that carry sewage from home and businesses to the main sewers. Ordinarily, the network of pipes relies on gravity for the waste to flow into the main sewer. However, in low-lying areas where the main sewer sits on higher ground …

    • 160KW 220HP 20M3/H Multistage Centrifugal Pump
      160KW 220HP 20M3/H Multistage Centrifugal Pump

      160KW 220HP 20M3/H Multistage Centrifugal Pump Introduction The 160 KW 220HP Horizontal Multistage Water Pump is horizontal multistage centrifugal pump. This Electric Multistage Pump has developed successfully based on introduction, digestion and absorption of advanced technologies. The products not only possesses the high efficiency, good cavitation performance but also operates smoothly and reliably. Flow passage …

    • 15KW Single Stage Single Suction Centrifugal Pump
      15KW Single Stage Single Suction Centrifugal Pump

      15KW Single Stage Single Suction Centrifugal Pump Introduction Single stage single suction centrifugal pump suitable for pumping clean water or liquids which chemical and physical property is similar to water. So single suction centrifugal pump is widely used in water transport, water supply and distribution, irrigation, drainage and flood control, district cooling/heating and fire fighting. …

    • 37KW 50HP 72 M3/H Vertical Pump
      37KW 50HP 72 M3/H Vertical Pump

      37KW 50HP 72 M3/H Vertical Pump Introduction The 37kw vertical multistage centrifugal pump is made up of a motor and a pump. The pump shaft and the motor shaft are coupled by a shell-type coupling to ensure that the pump and the motor are absolutely coaxial, so that the pump runs smoothly and the noise …

    • 22KW 30HP 90M3/H 60M Head Deep Well Submersible Pump
      22KW 30HP 90M3/H 60M Head Deep Well Submersible Pump

      22KW 30HP Submersible borehole pump, suitable for pumping clean water. This pump carries drinking water approval. The pump is fitted with a 22 kW motor with sand shield, mechanical shaft seal, water-lubricated journal bearings and a volume compensating diaphragm. The motor is a canned type submersible motor offering good mechanical stability and high efficiency. Suitable …

    • 90KW 120HP 100M3/H Stainless Steel Material Submersible Pump
      90KW 120HP 100M3/H Stainless Steel Material Submersible Pump

      Since its foundation in 1980s in China, Shenlong has been engaged in the manufacture, supply and sales of pumps and related equipment, with submersible pumps being key products. As well as producing general drainage pumps, Shenlong puts great effort into applications for difficult-to-handle liquids, such as corrosive and high temperature liquids and seawater. 90kw 100m3/hr …